User's Manual

ManualsBrandsNokia Solutions and Networks ManualsElectronicsSC4812T-MF 1X/1X-EVDO @ 800 Mhz CDMA BTS

131

132

133

134

135

136

137

138

139

140

Verify and Upgrade rommon Version

68P09258A31–A

Oct 2003

1X SCt 4812T BTS Optimization/ATP

J-60

Table J-13: Verify and Replace Installed rommon Version Using a tftp Server

Step Action

NOTE

The IOS defaults to the CF memory card (slot0:) directory unless the present working directory has

been changed using the

cd command. Determine the present working directory by entering pwd. If

the present working directory has been changed, enter the command

cd slot0: to return to the default

setting.

Determine the amount of memory available (bytes free) on the CF memory card by entering the dir

command. A response similar to the following will be displayed:

BTSRTR1#dir

Directory of slot0:/

1 –rw– 7051976 Sep 23 2002 07:24:18 mwr1941–i–mz.122–8.MC2b.bin

2 –rw– 2212 Mar 01 1993 00:14:48 canned–config

31932416 bytes total (24885606 bytes free)

Router#

Be sure there is at least 1 MB (1048580) of free memory.

NOTE

A rommon version file requires approximately 0.7 MB.

12 Begin to copy the required version of the rommon file from the LMF computer to the BTS router by entering

the following:

copy tftp:new_rommon_filename slot0:

Where new_rommon_filename = the filename of the required rommon version for the BTS router.

A response similar to the following will be displayed:

BTSRTR1#copy tftp:MWR1941_RM2.srec.122–8r.MC3.bin slot0:

Address or name of remote host [100.100.100.1]?

13 If the default IP address displayed in the prompt is correct, press the Enter key to accept it. If it is

missing or not correct, enter the correct IP address for the LMF computer. A response similar to the

following will be displayed if the default filename is selected:

Address or name of remote host [100.100.100.1]?

Source filename [MWR1941_RM2.srec.122–8r.MC3.bin]?

14 If the default filename displayed in the prompt is correct, press the Enter key to accept it. If it is

missing or not correct, enter the correct filename. A response similar to the following will be

displayed if the default filename is selected:

Source filename [MWR1941_RM2.srec.122–8r.MC3.bin]?

Destination filename [MWR1941_RM2.srec.122–8r.MC3.bin]?

. . . continued on next page