User's Manual

Verify and Upgrade rommon Version68P09258A31–A
Oct 2003
1X SCt 4812T BTS Optimization/ATP
J-57
Method 1: In–Router Verification and Replacement of Installed rommon
Version
Description
This procedure covers using an LMF computer equipped with a tftp
server application to perform the following activities:
1. Verify the rommon version loaded and running on a BTS router
2. Replace the rommon version installed in a BTS router
Additional required equipment/software
For this method, the following equipment and software application is
required in addition to the common items required for both methods:
S Cable, Ethernet crossover, Category 5E or better, unshielded twisted
pair, two 8–contact modular plugs, in one of the following lengths, as
determined necessary:
– 0.3 m (11.8 in) (Motorola pn 3088643C07)
– 0.6 m (23.6 in)(Motorola pn 3088643C13)
– 1.0 m (39.4 in) (Motorola pn 3088643C15)
– 2.1 m (84 in) (Motorola pn 3088643C08)
– 3.0 m (120 in) (Motorola pn 3088643C09)
S A tftp server software application (refer to the Setting Up the TFTP
Server – Procedure in Cellular System Administration – CDMA
OnLine Documentation) such as:
– Cisco tftp server
– PumpKIN tftp server
– Any other equivalent tftp server application
Prerequisites
The following are required prior to performing this procedure:
S The LMF computer and BTS router have been prepared for tftp file
transfer and are operating as they would be after performing the
procedures in Table J-4, Table J-5, Table J-6, and steps 1 through 8 of
Table J-7
S A copy of the required rommon version is loaded into the tftp default
directory of the LMF computer
Verifying and replacing installed rommon version
Follow the procedure in Table J-13 to verify and, if necessary, replace
the installed rommon version using the tftp server application.
J