User's Manual
Replacing Installed BTS Router CF Memory Card IOS Version68P09258A31–A
Oct 2003
1X SCt 4812T BTS Optimization/ATP
J-53
Table J-12: Use CF Memory Card Reader to Place IOS File
First in CF Memory Card File Sequence
Step Action
17 Display the directory of the CF memory card to confirm the IOS file transfer by entering the dir
command. A response similar to the following will be displayed:
Router#dir
Directory of slot0:/
1 –rw– 7051976 Sep 23 2002 07:24:18 mwr1941–i–mz.122–8.MC2a.bin
31932416 bytes total (248880440 bytes free)
Router#
18 Copy the canned configuration file to the CF memory card by entering the following:
copy tftp:btsrtr_canned.color slot0:canned–config
Where color = blue or red, as applicable.
A response similar to the following will be displayed:
BTSRTR1#copy tftp:btsrtr_canned.blue slot0:canned–config
Address or name of remote host [100.100.100.1]?
19 If the default IP address for the LMF computer displayed in the prompt is correct, press the Enter key
to accept it. If it is missing or not correct, enter the correct IP address.
A response similar to the following will be displayed if the default filename is accepted:
Destination filename [canned–config]?
2212 bytes copied in 0.208 secs
Router#
20 At the prompt for the destination filename, press the Enter key. A response similar to the following
will be displayed:
BTSRTR1#copy tftp:btsrtr_canned.blue slot0:canned–config
Address or name of remote host []? 100.100.100.1
Destination filename [canned–config]?
Loading btsrtr_canned.blue from 100.100.100.1 (via Ethernet0/0): !
[OK – 2457/4096 bytes]
2457 bytes copied in 84.724 secs (29 bytes/sec)
BTSRTR1#
21 Determine if the IOS file is now the first file displayed in the directory listing by entering the dir
command. A response similar to the following will be displayed:
Router#dir
Directory of slot0:/
1 –rw– 7051976 Mar 01 1993 00:14:48 mwr1941–i–mz.122–8.MC2a.bin
2 –rw– 2212 Sep 23 2002 07:24:18 canned–config
31932416 bytes total (24878228 bytes free)
Router#
22 If the IOS file is the first file displayed, as shown in step 21, above, proceed to step 30.
. . . continued on next page
J