User's Manual

ManualsBrandsNokia Solutions and Networks ManualsElectronicsSC4812T-MF 1X/1X-EVDO @ 800 Mhz CDMA BTS

121

122

123

124

125

126

127

128

129

130

Replacing Installed BTS Router CF Memory Card IOS Version68P09258A31–A

Oct 2003

1X SCt 4812T BTS Optimization/ATP

J-49

Table J-12: Use CF Memory Card Reader to Place IOS File

First in CF Memory Card File Sequence

Step Action

CAUTION

The file sequence on the CF memory card can not be verified with application programs which place the listed

file names in alphabetical order (for example, certain Unix telnet applications, Unix directory listing

commands, and Windows file managers such as Windows Explorer). This procedure is intended for use only

with applications, such as HyperTerminal, which do not list directory contents alphabetically.

1 This procedure assumes that the LMF computer and BTS router have been prepared for CF memory

card reader file transfer and are operating as they would be after performing the procedures in

Table J-8 and steps 1 through 5 of Table J-9. If necessary, perform these procedures now.

NOTE

The IOS present working directory defaults to the CF memory card (slot0:) directory unless the

present working directory has been changed using the

cd command. Determine the present working

directory by entering

pwd. If the present working directory has been changed, enter the command cd

slot0: to return to the default setting.

With the CF memory card still installed in the router, display a CF memory card directory listing if

one is not showing by entering the

dir command. A response similar to the following will be

displayed:

Router#dir slot0:

Directory of slot0:/

2 –rw– 2212 Mar 01 1993 00:14:48 canned–config

1 –rw– 7051976 Sep 23 2002 07:24:18 mwr1941–i–mz.122–8.MC2a.bin

31932416 bytes total (24878228 bytes free)

Router#

3 Verify that the IOS file is not the first file on the CF memory card.

4 If a tftp server application is not available on the LMF computer, skip to step 23.

5 If a tftp server is available on the LMF computer, connect the Ethernet crossover cable as shown in

Figure J-4.

6 If it has not been done, configure the LMF computer NIC as directed in Table J-4.

. . . continued on next page