User's Manual

Replacing Installed BTS Router CF Memory Card IOS Version
68P09258A31–A
Oct 2003
1X SCt 4812T BTS Optimization/ATP
J-46
Table J-11: Using a CF Memory Card Reader for Replacing
Loaded IOS Version and Verifying File Sequence Position
Step Action
4 When all files on the CF memory card have been deleted or moved, as applicable, highlight the
directory in the left–hand pane where the required IOS version and canned configuration files are
stored.
5 Verify that all files from the CF memory card which must be retained were moved to the directory by
checking the filenames in the right–hand pane.
6 Scroll the left–hand pane of Windows Explorer to locate the CF memory card reader icon.
7 In the right–hand pane, highlight the icon for the required version of the IOS.
8 Drag and drop the IOS icon to the CF memory card reader icon to copy it to the CF memory card.
9 If an additional file in the LMF computer directory must be moved to the CF memory card, perform
the following:
9a – In the right–hand pane, highlight one additional file which is to be moved to the CF memory card.
9b – While holding down the Ctrl key on the LMF computer, drag and drop the highlighted file into
the CF memory card reader directory in the left–hand pane.
9c – If additional files in the directory must be placed on the CF memory card, repeat steps 9a and 9b
for each file until all files have been moved one at a time from the LMF computer to the CF
memory card.
10 In the left–hand pane, highlight the CF memory card reader icon.
11 Verify that all required files were moved to the CF memory card by checking the filenames in the
right–hand pane.
12 Scroll the left–hand pane of Windows Explorer to locate the LMF computer directory where the
required IOS version and canned configuration files are stored.
13 Highlight the directory in the left–hand pane.
14 If this procedure was entered from step 17 of Table J-8, return to Table J-8, step 18.
15 If no other file transfer activities between the LMF computer and CF memory card are required at this
time, click Files > Close to close Windows Explorer.
16 Remove the CF memory card from the card reader and install it in the BTS router by following the
procedure in the 1X SC 4812T BTS FRU Guide .
17 At this point, the router should be powered up and displaying the user EXEC prompt in the
HyperTerminal window of the LMF computer communication session. If it is not, perform steps 1
through 6 of Table J-8.
18 At the Router> user EXEC mode prompt, enter the following to access the privileged EXEC mode:
enable
A response similar to the following will be displayed:
Router>enable
Router#
. . . continued on next page
J