User's Manual

Verifying IOS Canned Version of the CF Memory Card68P09258A31–A
Oct 2003
1X SCt 4812T BTS Optimization/ATP
J-31
Table J-8: Transfer Canned Configuration File to CF Memory Card with CF Memory Card Reader
Step Action
2 Connect the LMF computer to the BTS router and start a HyperTerminal communication session with
the router by following the procedure in Table J-2.
3 If it has not been done, be sure the +27 Vdc power supply output is OFF, and connect the BTS router
to the +27 Vdc power supply.
4
* IMPORTANT
In this step do not touch the computer keyboard until the router completes the boot process. The router
will buffer any keystrokes made during the boot process and interpret them as commands to be
executed immediately following boot completion.
Apply power to the router and allow it to complete boot–up.
5 If a message similar to the following, is displayed, press the Enter key and proceed to step 7:
Press RETURN to get started!
6 If a message similar to the following, is displayed type no and press the Enter key:
Basic management setup configures only enough connectivity
for management of the system, extended setup will ask you
to configure each interface on the system
Would you like to enter basic management setup? [yes/no]:
A response similar to the following will be displayed:
Would you like to enter basic management setup? [yes/no]: no
Cisco Internetwork Operating System Software
IOS (tm) 1941 Software (MWR1941–I–M), Version 12.2(20020127:101239
Copyright (c) 1986–2002 by cisco Systems, Inc.
Compiled Sun 27–Jan–02 06:08 by walrobin
Router>
7
CAUTION
Use only a card reader specifically designed for CF memory cards to perform this procedure. Card
readers for other non–volatile, solid–state memory devices such as Smart Media cards will not work
with the CF memory cards used in the MWR 1941 routers.
If it has not been done, follow the CF memory card reader manufacturer’s instructions to load the CF
memory card driver application for the operating system being used onto the LMF computer.
8 Connect the CF memory card reader to the LMF computer following the card reader manufacturer’s
instructions.
9 Remove the CF memory card from the BTS router by following the procedure in the
1X SC 4812T BTS FRU Guide
10 Insert the CF memory card into the card reader as specified by the card reader manufacturer’s
instructions.
11 On the LMF computer, click Start > Programs > Windows Explorer to open Windows Explorer.
. . . continued on next page
J