User's Manual

Verifying IOS Canned Version of the CF Memory Card68P09258A31–A
Oct 2003
1X SCt 4812T BTS Optimization/ATP
J-23
Verifying IOS Version and Canned Configuration File
TFTP Transfer to the BTS Router
Prerequisites – The following is required prior to performing this
procedure:
S A copy of the required MWR 1941 router IOS version file is installed
in the default tftp directory (transfer the file to the LMF computer
using FTP, internet download, or media such as a Zip disk; file size is
approximately 7–8 MB)
IOS verification and canned configuration file transfer – Follow the
procedure in Table J-7 to verify the loaded IOS version and transfer the
canned configuration files from the LMF computer to the BTS router CF
memory card.
NOTE
IMPORTANT: MWR 1941 routers must be loaded with IOS
version mwr1900–i–mz.122–8.MC2d.bin or later. This router
model will not function properly with earlier IOS versions.
NOTE
This procedure does not cover all aspects of BTS router
operation and programming. Before performing this procedure,
review BTS router initialization, operation, and programming
information and procedures in MWR1941 Wireless Mobile Edge
Router Software Configuration Guide; part number
78–13983–01. Have this publication available for reference
while performing this procedure.
Table J-7: Transfer Canned Configuration Files to the BTS Router Using a TFTP Server
Step Action
CAUTION
If personal firewall and/or intrusion detection software such as Black ICE is running on the LMF computer,
shut it down before performing this procedure. If this is not done, the tftp transfer process will not operate.
1 On the LMF computer, if it has not been done, start the tftp server according to the manufacturer’s
directions (refer to the Setting Up the TFTP Server – Procedure in the Cellular System Administration
– CDMA OnLine Documentation).
* IMPORTANT
MWR 1941 routers must be loaded with IOS version mwr1900–i–mz.122–8.MC2d.bin or later. This
router model will not function properly with earlier IOS versions.
2 If a HyperTerminal communication session with the BTS router is not running, start one following the
procedure in Table J-2.
3 In the HyperTerminal window, the router must be in the privileged EXEC mode, as indicated by a
number sign at the end of the prompt:
BTSRTR1#
4 Be sure the Ethernet crossover cable is connected between the LMF computer NIC port and the BTS
router FE 0 port (see Figure J-4).
. . . continued on next page
J