User's Manual

ManualsBrandsNokia Solutions and Networks ManualsElectronicsSC4812T-MF 1X/1X-EVDO @ 800 Mhz CDMA BTS

Table of Contents

68P09258A31–A

1X SCt 4812T BTS Optimization/ATP

xii

Oct 2003

Figure 3-16: TX Calibration Test Setup – CyberTest (IS–95A/B) and

Agilent 8935 (IS–95A/B and CDMA2000 1X), and Advantest R3465 3-65 . . . . . . . . . . . . . . . . . . . . . . . . .

Figure 3-17: TX Calibration Test Setup –

Agilent E4406A and Advantest R3567 (IS–95A/B and CDMA2000 1X) 3-66 . . . . . . . . . . . . . . . . . . . . . . .

Figure 3-18: TX Calibration Test Setup – Agilent E7495A (IS–95A/B and CDMA2000 1X) 3-67 . . . . . .

Figure 3-19: Optimization/ATP Test Setup Calibration – Agilent 8935 3-68 . . . . . . . . . . . . . . . . . . . . . . . .

Figure 3-20: Optimization/ATP Test Setup – HP 8921 3-69 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Figure 3-21: IS–95A/B and CDMA2000 1X Optimization/ATP Test Setup –

Advantest R3267/3562, Agilent E4432B/E4406A 3-70 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Figure 3-22: IS–95A/B and CDMA2000 1X Optimization/ATP Test Setup –

Agilent E7495A 3-71 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Figure 3-23: Typical TX ATP Setup with Directional Coupler 3-72 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Figure 3-24: Typical RX ATP Setup with Directional Coupler 3-73 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Figure 3-25: Cal Setup for TX/Duplexed RX Test Cabling

Using Signal Generator & Spectrum Analyzer 3-81 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Figure 3-26: Cal Setup for Non–Duplexed RX Test Cabling

Using Signal Generator & Spectrum Analyzer 3-82 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Figure 3-27: SC 4812T C–CCP Shelf 3-112 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Figure 3-28: –48 V BTS Power Conversion Shelf 3-112 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Figure 3-29: +27 V BTS C-CCP Fan Modules 3-114 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Figure 3-30: –48 V BTS C-CCP and Power Conversion Shelf Fan Modules 3-114 . . . . . . . . . . . . . . . . . .

Figure 3-31: Alarm Connector Location and Connector Pin Numbering 3-121 . . . . . . . . . . . . . . . . . . . . . .

Figure 3-32: AMR Connector Pin Numbering 3-122 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Figure 4-1: TX Mask Verification Spectrum Analyzer Display 4-12 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Figure 4-2: Code Domain Power and Noise Floor Levels 4-14 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Figure 5-1: MGLI2/GLI2 MMI Port Connection 5-6 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Figure 5-2: Site and Span I/O Boards T1 Span Connections 5-9 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Figure 6-1: CSM Front Panel Indicators & Monitor Ports 6-22 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Figure 6-2: GLI2 Front Panel 6-25 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Figure 6-3: GLI3 Front Panel 6-26 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Figure 6-4: MCC Front Panel 6-28 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Figure 6-5: MGLI/GLI Board MMI Connection Detail 6-30 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Figure 6-6: GLI3 Board MMI Connection Detail 6-31 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Figure E-1: North American PCS 1900 MHz Frequency Spectrum E-2 . . . . . . . . . . . . . . . . . . . . . . . . . .

Figure E-2: North American Cellular Telephone System Frequency Spectrum E-5 . . . . . . . . . . . . . . . .

Figure E-3: 1700 MHz PCS Frequency Spectrum E-7 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Figure F-1: Agilent E7495A Pre–Power Sensor Calibration connection F-5 . . . . . . . . . . . . . . . . . . . . . .

Figure F-2: Agilent E7495A Power Sensor Calibration connection F-5 . . . . . . . . . . . . . . . . . . . . . . . . . . .

Figure F-3: Setting Agilent E4406A GPIB Address F-6 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Figure F-4: Setting Agilent E4432B GPIB Address F-7 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Figure F-5: Setting Advantest R3267 GPIB Address F-8 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Figure F-6: Advantest R3562 GPIB Address Switch Setting F-9 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Figure F-7: Agilent 8935 Test Set F-10 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .