User's Manual

Prepare to Leave the Site

68P09258A31–A

Oct 2003

1X SCt 4812T BTS Optimization/ATP

5-10

Reset All Devices and Initialize Site Remotely

Devices in the BTS should not be left with data and code loaded from

the LMF. The configuration data and code loads used for normal

operation could be different from those stored in the LMF files. Perform

the procedure in Table 5-8 to reset all devices and initialize site remotely.

Table 5-8: Reset BTS Devices and Remote Site Initialization

Step Action

1 Terminate the LMF session by following the procedures in Table 5-6.

2 Reconnect spans by following the procedure in Table 5-7.

3 – If BTS is configured for circuit operation, go to Step 4.

– If BTS is configured for packet operation, go to Step 5.

4 Circuit BTS Procedure:

4a From the BTS site, contact the OMC–R and request the operator to perform a BTS reset.

At the BTS site:

– unseat one GLI card at a time and wait for 30 seconds;

– reseat the GLI and wait for it to complete its initialization (this takes about one minute);

– repeat for the second GLI.

4b Depending on the number of installed operational GLI cards, perform one of the following:

– With fully redundant GLIs, contact the OMC–R and request the operator to run the ACTIVATE

command for the BTS.

– For a non–redundant GLI or a frame where the redundant GLI is not operational, contact the

OMC–R and request the operator:

S ACTIVATE the GLI to set the Nextload attribute for the GLI to the one for the current BSS

software version;

S Disable the GLI;

S Enable the GLI to allow the MM to load the software version specified by the Nextload

attribute;

S Once the GLI is INS_ACT, contact the OMC–R and request the operator ACTIVATE the BTS.

– Once the GLI cards are loaded with the specified code version, the active GLI will verify and

update, as required, the RAM and, if it is necessary, ROM code loads for the installed CSM,

MCC, and BBX cards using the DLM.

. . . continued on next page