User's Manual

ManualsBrandsNokia Solutions and Networks ManualsElectronicsSC4812T-MF 1X/1X-EVDO @ 800 Mhz CDMA BTS

121

122

123

124

125

126

127

128

129

130

Prepare to Leave the Site

68P09258A31–A

Oct 2003

1X SCt 4812T BTS Optimization/ATP

5-6

Figure 5-1: MGLI2/GLI2 MMI Port Connection

ÂÂÂÂÂÂÂ

FW00344

9–PIN TO 9– PIN

RS–232 CABLE

NULL MODEM BOARD

(PART# 8484877P01)

RS–232 CABLE

FROM LMF COM1

PORT

MMI SERIAL PORT

GLI BOARD

Set BTS Site Span Configuration

Perform the procedure in Table 5-5 to configure the Span Framing

Format and Line Build Out (LBO) parameters. ALL MGLI2/GLI2

boards in all C–CCP shelves that terminate a T1/E1 span must be

configured.

NOTE

Perform the following procedure ONLY if span configurations

loaded in the MGLI2/GLI2s do not match those in the

OMCR/CBSC data base, AND ONLY when the exact

configuration data is available. Loading incorrect span

configuration data will render the site inoperable.

Table 5-5: Set BTS Span Parameter Configuration

Step Action

1 If not already done, connect a serial cable from the LMF COM1 port (via null modem board) to the

front panel of the MGLI2 MMI port (see Figure 5-1).

2 Start an MMI communication session with CSM–1 by using the Windows desktop shortcut icon (see

Table 3-3 on page 3-13).

NOTE

The LMF program must not be running when a Hyperterminal session is started if COM1 is being

used for the MMI session.

. . . continued on next page