User's Manual

Prepare to Leave the Site

68P09258A31–A

Oct 2003

1X SCt 4812T BTS Optimization/ATP

5-4

Prepare to Leave the Site

External Test Equipment Removal

Perform the procedure in Table 5-3 to disconnect the test equipment and

configure the BTS for active service.

Table 5-3: External Test Equipment Removal

Step Action

1 Disconnect all external test equipment from all TX and RX

connectors on the top of the frame.

2 Reconnect and visually inspect all TX and RX antenna feed

lines at the top of the frame.

CAUTION

Verify that all sector antenna feed lines are connected to the

correct ports on the frame. Crossed antenna cables will cause

system degradation of call processing.

NOTE

Each module or device can be in any state prior to downloading.

Each module or device will be in an OOS_RAM state after

downloading has completed.

– For all LMF commands, information in italics represents

valid ranges for that command field.

– Only those fields requiring an input will be specified.

Default values for other fields will be assumed.

– For more complete command examples (including system

response details), refer to the CDMA LMF User Guide.