User's Manual

Updating Calibration Data Files
68P09258A31–A
Oct 2003
1X SCt 4812T BTS Optimization/ATP
5-2
Updating Calibration Data Files
Software Release caveats
With Software Release 2.16.1.x, the packet BTS will NOT detect a new
calibration file on the OMC–R. A manual workaround is available in
bulletin cdma_g_bts_059. This will be corrected in Software Release
2.16.3.
Software Release 2.16.3 will allow the user to load the calibration file
from the LMF directly onto the MGLI. The MGLI will then ftp the new
calibration file to the OMC–R, thereby eliminating the need for the user
to place the calibration file at the OMC–R.
Copy and Load Cal File to to CBSC
After completing the TX calibration and audit, updated CAL file
information must be moved from the LMF Windows environment back
to the CBSC, a Unix environment. The following procedures detail
moving files from one environment to the other.
Copying CAL files from LMF to a Diskette
Follow the procedures in Table 5-1 to copy the CAL files from an LMF
computer to a 3.5 diskette.
Table 5-1: Copying CAL Files to a Diskette
Step Action
1 With Windows running on the LMF computer, insert a disk into Drive A:\.
2 Launch the Windows Explorer application program from the Start > Programs menu list.
3 Select the applicable <x>:\<lmf home directory/cdma/bts–# folder.
4 Drag the bts–#.cal file to Drive A.
5 Repeat Steps 3 and 4, as required, for other bts–# folders.
5