User's Manual

Automated Acceptance Test Procedures

68P09258A31–A

Oct 2003

1X SCt 4812T BTS Optimization/ATP

4-6

Required Test Equipment

The following test equipment is required:

S LMF

S Power meter (used with HP8921A/600 and Advantest R3465)

S Communications system analyzer

S Signal generator for FER testing (required for all communications

system analyzers for 1X FER)

WARNING

– Before installing any test equipment directly to any BTS

TX OUT connector, verify that there are no CDMA

channels keyed.

– At active sites, have the OMCR/CBSC place the carrier

assigned to the PAs under test OOS. Failure to do so can

result in serious personal injury and/or equipment damage.

NOTE

The test equipment must be re–calibrated before using it to

perform the TX Acceptance Tests.