User's Manual Part 4

Compact BTS Expansion Configuration (Indoor) – continued

E-16 1X SC480 BTS Hardware Installation, Optimization/ATP, and FRU MAY 2004

PRELIMINARY

Installation Procedure for

Expansion Compact BTS

without cCLPA

Follow the procedure in Table E-2 for installation of expansion Compact

BTS without cCLPAs. Table E-7 through Table E-9 (less the cCLPA) are

virtually the same and are can be used for the diagrams without cCLPA,

and so separate tables will not be included here.

Table E-10: Procedure for Installing Expansion Compact BTS without cCLPA

Step Action

1 Follow the procedure in Chapter 4 for installing a Compact BTS in a rack.

2 For a 3 BTS expansion configuration, follow Figure E-7. Proceed to step 3.

2a For a 2 BTS expansion configuration, follow Figure E-8. Proceed to step 3.

2b For a 1 BTS expansion configuration, follow Figure E-9. Proceed to step 3.

3 If not using conduit, dress cables as necessary.

4 Perform Optimization and ATP as described in Chapter 6. LMF Help provides further information.

Starter and Expansion BTSes

Interconnect Cabling without

cCLPA

Table E-7 through Table E-9 are virtually the same and are can be used

for the diagrams without cCLPA. Separate tables will not be included

here.