User's Manual Part 4

Compact BTS Expansion Configuration (Indoor) – continued
E-14 1X SC480 BTS Hardware Installation, Optimization/ATP, and FRU MAY 2004
PRELIMINARY
Starter and One Expansion
BTSes Interconnect Cabling for
Single cCLPA
Table E-9 shows in tabular format the interconnect cabling of
Figure E-6.
Table E-9: Starter and One Expansion BTS Interconnect Cabling
for Circuit or Packet Configuration with Single cCLPA
BTS Expansion 1 Expansion 2 Expansion 3 cCLPA
Starter TX–1 – – – cCLPA–1 (TX IN)
Starter TX–2 – – – –
Starter EXP–TX 2 EXP TX–2 – – –
Starter EXP–TX 3 – – – –
Starter EXP–TX 4 – – – –
Starter RX MAIN – – – Antenna
Starter EXP–RX MAIN 2 – – – –
Starter EXP–RX MAIN 3 EXP – RX
MAIN 2
– – *cCLPA–1
Starter EXP–RX MAIN 4 – – – –
Starter RX DIV – – – cCLPA–1
(RX OUT)
Starter EXP–RX DIV 2 EXP – RX
DIV 2
– – *cCLPA–1
Starter EXP–RX DIV 3 – – – –
Starter EXP–RX DIV 4 – – – –
Starter SDCX 2 SDC INPUT
EXPANSION
– – –
Starter SDCX 3 – – – –
Starter SDCX 4 – – – –
* Not actual physical connections to cCLPA, but software connections through the Starter BTS.
E