User's Manual Part 4

Basic Troubleshooting – continued

11-4 1X SC480 BTS Hardware Installation, Optimization/ATP, and FRU MAY 2004

PRELIMINARY

Table 11-3: GLI IP Address Setting

Step Action

5 Set the GLI route default to default by entering the following command:

config route default default

A response similar to the following will be displayed:

GLI3>config route default default

_esh_config_route_default(): param_delete(): 0x00050001

route: default gateway set to DEFAULT

NOTE

Changes to the settings will not take effect unless the GLI is reset.

6 When changes are completed, close the MMI session, and reset the GLI card.

7 Once the GLI is reset, re–establish MMI communication with it and issue the following command to

confirm its IP address and subnet mask settings:

config lg0 current

A response similar to the following will be displayed:

GLI3>config lg0 current

lg0: IP address is set to

DEFAULT (configured based on card location)

lg0: netmask is set to

DEFAULT (255.255.255.128)