User's Manual Part 4

Verifying and Setting GPIB Addresses – continued

B-10 1X SC480 BTS Hardware Installation, Optimization/ATP, and FRU MAY 2004

PRELIMINARY

Table B-7: Verify and/or Change Agilent 8935 (formerly HP 8935) GPIB Address

Step Action

NOTE

The HP I/O configuration MUST be set to Talk & Listen, or no device on the GPIB will be

accessible. (Consult test equipment OEM documentation for additional information as required.)

To verify that the GPIB addresses are set correctly, press Shift and LOCAL on the Agilent 8935.

– The current HP–IB address is displayed at the top of the screen.

NOTE

HP–IB is the same as GPIB.

2 If the current GPIB address is not set to 18, perform the following to change it:

2a – Press Shift and Inst Config.

2b – Turn the Cursor Control knob to move the cursor to the HP–IB Adrs field.

2c – Press the Cursor Control knob to select the field.

2d – Turn the Cursor Control knob as required to change the address to 18.

2e – Press the Cursor Control knob to set the address.

3 Press Preset to return to normal operation.