User's Manual Part 4

Change GLI3 Span Parameter Settings – continued

G-10 1X SC480 BTS Hardware Installation, Optimization/ATP, and FRU MAY 2004

PRELIMINARY

Table G-3: Set GLI3 Span Parameter Configuration

Step Action

10 At the entry prompt (>), enter the code for the required equalization from the list as shown in the

following example:

> 0

A response similar to the following will be displayed :

> 0

The value has been programmed. It will take effect after the next reset.

GLI2>

11 Repeat steps 8 through 10 for each in–use span.

NOTE

This step must be performed for GLI3 cards operating on a packet image to ensure the span parameter

changes will replace the previous settings.

For a GLI3 card in packet mode, enter the following:

rmfile /nvram00/config/hlp_param.txt

A response similar to the following will be displayed :

GLI3> rmfile /nvram00/config/hlp_param.txt

11.24.2003 23:14:57 MGLI–004–1 CC PRESENT BTS–CDMA 16.40.00.09

Removing file: /nvram00/config/hlp_param.txt

Successfully removed file: /nvram00/config/hlp_param.txt

GLI3>

* IMPORTANT

S After executing the config ni format, config ni linkspeed, and/or config ni equal commands,

the affected MGLI/GLI board MUST be reset and reloaded for changes to take effect.

S Although defaults are shown in the software, always consult site–specific documentation for span

type, equalization, and linkspeed used at the site where the cards are to be installed.

Reset the card using the MMI reset command.

. . . continued on next page