User's Manual Part 3

Accessing OMC–R CLI Window

10-2 1X SC480 BTS Hardware Installation, Optimization/ATP, and FRU MAY 2004

PRELIMINARY

Accessing OMC–R CLI Window

Many of the FRU procedures require the OMC–R operator to manipulate

BTS logical devices. This is achieved via UNO or the OMC–R

(Operations and Maintenance Center – Radio) Command Line Interface

(CLI).

The operator enters commands via UNO or OMC–R CLI.

Should there be any issues which affect UNO or the

OMC–R CLI operations, command dependent replacement

procedures cannot be performed.

IMPORTANT

OMC–R CLI access procedure

The following procedure is performed by the OMC–R operator at the

OMC–R terminal.

Table 10-1: Login and Access Alarm Window Procedure

n Step Action

1 Login by entering the user name.

2 Enter the password at the system prompt.

3 Open an UNO Alarm Manager window and an OMC–R CLI window from the pull down menu

using the mouse button.

4 Verify that the filter display is set to the BTS–# where the work is being performed. This ensures

that any BTS–# alarms, encountered while installing the hardware, can be observed and rectified.