User's Manual Part 3

ManualsBrandsNokia Solutions and Networks ManualsElectronics1X SC480 BTS Microcell Base Station Transmitter

141

142

143

144

145

146

147

148

149

150

Packet BTS Start–Up Procedures – continued

MAY 2004 1X SC480 BTS Hardware Installation, Optimization/ATP, and FRU 10-59

PRELIMINARY

Restore Carrier Signaling Operations for

a Packet BTS

Restore carrier signaling operations according to the procedure in

Table 10-13.

Table 10-13: Restore Carrier Signaling Operations Procedure For a Packet BTS

n Step Action

AT THE OMCR

1 Open a CLI window. Refer to the Accessing OMCR CLI Window section on page 10-2.

2 Unlock/enable the target carrier on all sector–carriers equipped for the BTS by repeatedly entering

either of the following commands at the prompt:

omc–000000>ENABLE CARRIER–<bts#>–<sector#>–<carrier#> UNC

omc–000000>UNLOCK CARRIER–<bts#>–<sector#>–<carrier#>

Repeat the command for each sector–carrier associated with the target carrier.

3 Observe that the system automatically returns a “Network Element State Change Event” message

for each CARRIER device and its associated BBX. These messages show the old and new states

for the devices. The new state should be UNLOCKED/ENABLED/ACTIVE.

4 Display the status of all devices at the BTS by entering the following command at the prompt:

omc–000000>DISPLAY BTS–<bts#> STATUS

Observe the system response.

Make sure that there are not more OOS_AUTOMATIC devices than what was observed in step 15

of the shut down carrier signaling functions procedure for a packet BTS Table 10-10.

If you did not redirect subscribers according to the steps in the shut down carrier signaling

functions procedure for a packet BTS Table 10-10, stop here.

If you did redirect subscribers according to the steps in the shut down carrier signaling functions

procedure for a packet BTS Table 10-10, perform the remaining steps of this table.

6 View the congestion control parameters for all carriers equipped for the applicable sector by

entering the following command at the prompt:

omc–000000>DISPLAY SECTOR–<bts#>–<sector#> CONGESTCONF

Observe the following typical system display response for sector 2:

CARRIER NEWCALL REG AGG

(bts#–sector#–carrier#) SET ALARMFLAG ALARMFLAG ALARMFLAG ANALOGREDIRECT GLOBALREDIRECT

––––––––––––––––––––––– ––– ––––––––– –––––––––– –––––––––– –––––––––––––– ––––––––––––––

146–2–1 1 ENABLE ENABLE ENABLE DISABLE ENABLE

146–2–2 1 ENABLE ENABLE ENABLE DISABLE ENABLE

. . . continued on next page