User's Manual Part 3

Circuit BTS Start–Up Procedures – continued

MAY 2004 1X SC480 BTS Hardware Installation, Optimization/ATP, and FRU 10-29

PRELIMINARY

Restore Carrier Signaling Operations for

a Circuit BTS

Restore carrier signaling operations according to the procedure in

Table 10-7.

Table 10-7: Restore Carrier Signaling Operations Procedure For a Circuit BTS

n Step Action

1 Open a CLI window. Refer to the Accessing OMCR CLI Window section on page 10-2.

2 Enable all BBX cards that were disabled in step 17 of the shut down carrier signaling functions

procedure for a circuit BTS Table 10-4 by entering the following command at the prompt:

omc–000000>ENABLE BBX–bts#–bbx# UNC

3 Display the status of all devices at the BTS by entering the following command at the prompt:

omc–000000>DISPLAY BTS–<bts#> STATUS

Observe the system response.

Make sure that there are not more OOS_AUTOMATIC devices than what was observed in step 15

of the shut down carrier signaling functions procedure for a circuit BTS Table 10-4. Verify that

the BBX cards have been enabled and are INS_ACTIVE and INS_STANDBY respectively.

If you did not redirect subscribers according to the steps in the shut down carrier signaling

functions procedure for a circuit BTS Table 10-4, stop here.

If you did redirect subscribers according to the steps in the shut down carrier signaling functions

procedure for a circuit BTS Table 10-4, perform the remaining steps of this table.

5 View the congestion control parameters for all carriers equipped for the applicable sector by

entering the following command at the prompt:

omc–000000>DISPLAY SECTOR–<bts#>–<sector#> CONGESTCONF

Observe the following typical system display response for sector 2:

CARRIER NEWCALL REG AGG

(bts#–sector#–carrier#) SET ALARMFLAG ALARMFLAG ALARMFLAG ANALOGREDIRECT GLOBALREDIRECT

––––––––––––––––––––––– ––– ––––––––– –––––––––– –––––––––– –––––––––––––– ––––––––––––––

1–1–1 1 ENABLE ENABLE ENABLE DISABLE ENABLE

. . . continued on next page