User's Manual Part 3

ManualsBrandsNokia Solutions and Networks ManualsElectronics1X SC480 BTS Microcell Base Station Transmitter

111

112

113

114

115

116

117

118

119

120

Circuit BTS Start–Up Procedures – continued

10-28 1X SC480 BTS Hardware Installation, Optimization/ATP, and FRU MAY 2004

PRELIMINARY

Table 10-6: Restore Sector Signaling Operations Procedure For a Circuit BTS

n ActionStep

* IMPORTANT

In this step, use the values recorded in step 3 of the shut down sector signaling functions

procedure for a circuit BTS Table 10-2 to answer the prompts for the EDIT SECTOR

REDIRECT command; except for record type enter 2.

NOTE

This step shows the entry of initial standard values which is consistent with the original example;

except record type must be 2. Your entries may be different.

9 Restore the values of all REDIRECT parameters by entering the following command at the

prompt:

omc–000000>EDIT SECTOR–<bts#>–<sector#> REDIRECT !

The system will prompt you to enter each command parameter one at a time. Answer the prompts

in the following order (Note that the following specified values are consistent with the original

example. Yours may be different):

<accolc0> enter N, <accolc1>enter N, ... <accolc15>enter N

<returniffail> , enter N

<recordtype> , enter 2

<expectedsid> , enter 0

<ignorecdma> , enter N

<sysordering> , enter CUSTOM

<rotatetimer> , enter 4

The system will display the command that will be sent. Verify the command syntax.

omc–000000>Accept [yes/no]?

Enter Y to accept the command or N to go back and enter the correct value(s).

10 View the status of the sector signaling REDIRECT parameters by entering the following command

at the prompt:

omc–000000>DISPLAY SECTOR–<bts#>–<sector#> REDIRECT

Ensure that the values in the system display response match the values input by the operator in

step 9 (see example below).

Access Overload Class Redirect Flags ROTATE

CARRIER ID RETURN 0 0 0 0 0 0 0 0 0 0 1 1 1 1 1 1 TIMER RECORD EXP IGNORE SYS

(bts–sector–carrier) IF FAIL 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 (SEC) TYPE SID CDMA ORDERING

–––––––––––––––––––– ––––––– – – – – – – – – – – – – – – – – ––––– –––– ––– –––– –––––––

CARRIER–1–1–1 N N N N N N N N N N N N N N N N N 4 2 0 N CUSTOM