User's Manual Part 3

Circuit BTS Start–Up Procedures

MAY 2004 1X SC480 BTS Hardware Installation, Optimization/ATP, and FRU 10-23

PRELIMINARY

Restore Site Signaling

Operations for a Circuit BTS

Restore site signaling operations according to the procedure in

Table 10-5.

Table 10-5: Restore Site Signaling Operations Procedure For a Circuit BTS

n Step Action

AT THE OMCR

1 Open a CLI window. Refer to the Accessing OMC–R CLI Window section on page 10-2.

2 Enable the BTS by entering the following command at the prompt:

omc–000000>ENABLE BTS–<bts#> UNC

3 Display the status of all devices at the BTS by entering the following command at the prompt:

omc–000000>DISPLAY BTS–<bts#> STATUS

Observe the system response.

Make sure that there are not more OOS_AUTOMATIC devices than what was observed in step 13

of the shut down site signaling functions procedure for a circuit BTS Table 10-2. Devices that

were previously OOS_AUTOMATIC may now be INS.

If you did not redirect subscribers according to the steps in the shut down site signaling functions

procedure for a circuit BTS Table 10-2, STOP here.

If you did redirect subscribers according to the steps in the shut down site signaling functions

procedure for a circuit BTS Table 10-2, perform the remaining steps of this table.

5 View the existing congestion control parameters for all carriers equipped for the BTS by entering

the following command at the prompt:

omc–000000>DISPLAY BTS–<bts#> CONGESTCONF

Observe the following typical system display response for a BTS:

CARRIER NEWCALL REG AGG

(bts#–sector#–carrier#) SET ALARMFLAG ALARMFLAG ALARMFLAG ANALOGREDIRECT GLOBALREDIRECT

––––––––––––––––––––––– ––– ––––––––– ––––––––– ––––––––– –––––––––––––– ––––––––––––––

1–1–1 1 ENABLE ENABLE ENABLE DISABLE ENABLE

. . . continued on next page