User's Manual Part 2

Test Set Calibration – continued
MAY 2004 1X SC480 BTS Hardware Installation, Optimization/ATP, and FRU 6-75
PRELIMINARY
Table 6-30: Procedure for Setting TX and RX Directional Coupler Loss Values
Step Action
6
Click on the Dismiss button to close the window.
NOTE
S Values entered or changed after the Save button is used will be lost when the window is dismissed.
S The In–Service Calibration check box in the Tools > Options > BTS Options tab must be
checked before entered TX coupler loss values will be used by the TX calibration and audit
functions.
S New or changed values will be used by the LMF as soon as they are saved. Logging out and logging
in again are not required to cause saved changes to take effect.
6