User's Manual Part 2

Download the BTS – continued

MAY 2004 1X SC480 BTS Hardware Installation, Optimization/ATP, and FRU 6-37

PRELIMINARY

RAM code can be downloaded to a device that is in any state. After the

download is started, the device being loaded will change to OOS_ROM

(blue). When the download is completed successfully, the device will

change to OOS_RAM (yellow).

When code is downloaded to a GLI, the LMF automatically also

downloads data and then enables the GLI. When enabled, the GLI will

change to INS_ACT (bright green).

For non–GLI devices, data must be downloaded after RAM code is

downloaded. To download data, the device state must be OOS_RAM

(yellow).

If an MCC–DO card is in use, it can only be loaded using the Local

Maintenance Tool (LMT). LMT is software designed specifically for the

MCC–DO card. To avoid confusion and duplication of effort, refer to

Motorola Lifecycles website at

http://www.motorola.com/networkoperators/CDMA–1xEV–DO.htm for

further information on LMT or MCC–DO.

The devices to be loaded with RAM code and data are:

S Group Line Interface III (GLI3)

S Clock Synchronization and Alarm card (CSA) (Only if new revision

code must be loaded)

S Multi–Channel CDMA (MCC–1X) cards

S Broad Band Transceiver (BBX–1X) cards

The GLI must be successfully downloaded with RAM code

and data, and in INS_ACT (bright green) status before

downloading any other device. The RAM code download

process for an GLI automatically downloads data and then

enables the GLI.

NOTE