User's Manual Part 2

Preparing the LMF – continued

MAY 2004 1X SC480 BTS Hardware Installation, Optimization/ATP, and FRU 6-11

PRELIMINARY

WinLMF Operating System

Installation

This section provides information and instructions for installing and

updating the WinLMF software and files.

First Time Installation Sequence

S Install Java Runtime Environment (JRE)

S Install U/WIN K–shell emulator

S Install WinLMF application programs

S Install/create BTS folders

Any time you install U/WIN, you must install the

WinLMF software because the installation of the WinLMF

modifies some of the files that are installed during the

U/Win installation. Installing U/Win over–writes these

modifications.

There are multiple binary image packages for installation

on the CD–ROM. When prompted, choose the load that

corresponds to the switch release that you currently have

installed. Perform the Device Images install after the

WinLMF installation.

If applicable, a separate CD ROM of BTS Binaries may be

available for binary updates.

NOTE

Follow the procedure in Table 6-2 to install the WinLMF application

program using the WinLMF CD ROM.

Table 6-2: Install WinLMF using CD ROM

n Step Action

1 Insert the WinLMF CD ROM disk into your disk drive and perform the following as required:

1a – If the Setup screen appears, follow the instructions displayed on the screen.

1b – If the Setup screen is not displayed, proceed to Step 2.

2 Click on the Start button

3 Select Run.

4 Enter d:\autorun in the Open box and click OK.

NOTE

If applicable, replace the letter d with the correct CD ROM drive letter.