User's Manual Part 2

RX FER Acceptance Test – continued

PRELIMINARY

1X SC480 BTS Hardware Installation, Optimization/ATP, and FRU

MAY 2004

7-22

Table 7-9: Test FER

Step Action

7 Verify that the correct channel number for the selected carrier is shown in the Carrier # Channels

box.

– If it is not, obtain the latest bts–#.cdf and cbsc–#.cdf files from the CBSC.

NOTE

If necessary, the correct channel number may be manually entered into the Carrier # Channels box.

* IMPORTANT

If a companion frame with the inter–frame diversity RX cabling disconnected is being tested do not

select BOTH in this step. The RX main and diversity paths must be tested separately for this

configuration because each requires a different Multi–Coupler Preselector type to provide the proper

test signal gain.

10 Select the appropriate RX branch (Both, Main, or Diversity) in the drop–down list.

11 In the Rate Set box, select the appropriate data rate (1=9600, 2=14400, 3=9600 1X) from the

drop–down list.

NOTE

The Rate Set selection of 3 is only available if 1X cards are selected for the test.

13 Click OK to display a status bar followed by a Directions pop-up window.

14 Follow cable connection directions as they are displayed, and click the Continue button to begin

testing.

– As the ATP process is completed, results will be displayed in the status report window.

15 Click the Save Results or Dismiss button.

NOTE

If Dismiss is used, the test results will not be saved in the test report file.