User's Manual Part 2

Automated Acceptance Test Procedure – Introduction – continued

MAY 2004

7-3

1X SC480 BTS Hardware Installation, Optimization/ATP, and FRU

PRELIMINARY

1. All transmit connectors must be properly terminated

for all ATP tests.

2. Before the FER is run, be sure that one of the

following is done:

– All transmitter connectors are properly terminated

– The Compact PA is turned OFF (circuit breakers

pulled)

Failure to observe these warnings may result in bodily

injury or equipment damage.

WARNING

EV–DO Optimization and ATP

Appendix A contains procedures for testing the DO card using the LMF.

The procedures are unproven at this time. To load the DO card, the Local

Maintenance Tool (LMT) must be used. For further information on the

LMT refer to the following manuals:

S LMT Command References – 68P09258A03

S LMT Operator’s Guide – 68P09258A04

There are ATP tests available specifically for DO. For further

information refer to the following manual:

S 1xEV–DO System ATP – 68P09258A02