User's Manual Part 1

Unpacking the Equipment – continued
MAY 2004
2-11
1X SC480 BTS Hardware Installation, Optimization/ATP, and FRU
PRELIMINARY
Unpacking a Cardboard or
Wood Container
Follow the procedure in Table 2-3 to unpack equipment from a container.
Table 2-3: Unpacking Equipment from a Cardboard or Wood Container
Step Action
1 Inspect the container for damage.
Cardboard Container
2 Open container using tin snips to cut each outer steel band or a knife (or equivalent) to cut the plastic
wrap that surrounds the container.
3 Remove equipment door key from top of container.
4 Lift off the cardboard cover.
5 Proceed to Table 2-4 or Table 2-5.
Wood Container
6 Perform step 1.
7 Loosen latches at the bottom of the container.
8 Remove clips holding the top pallet , and remove pallet from the container.
9 Remove equipment door key from pallet.
10 Proceed to Table 2-4 or Table 2-5.
Removing Outdoor Equipment
from a Container
Follow the procedure in Table 2-4 to remove the outdoor equipment
from a container. The following procedure starts with the TME removal
and continues through to the Pole Mounting Assembly. The order of
opening containers is not important, it is just for demonstration
purposes. The procedure is written for one set. Perform procedure as
many times as required to accommodate the site configuration.
Table 2-4: Procedure to Remove Outdoor Equipment from Container
Step Action
1 Open shipping container holding TME. Perform Table 2-3.
2 Remove the box containing the Wall Mounting Bracket from the insert.
3 Remove insert.
4 Remove cage style packing material surrounding the TME.
5 Using a knife or equivalent, carefuly cut through protective bag enclosing TME.
2