User's Manual Part 1

Site Inspections
PRELIMINARY
1X SC480 BTS Hardware Installation, Optimization/ATP, and FRU
MAY 2004
2-2
Inspection overview
Inspect the site to verify that the necessary equipment has been properly
installed. Also, as part of the inspection, verify that the equipment is
adequate to support the Motorola equipment. Not all inspections may
apply to every site. The site characteristics determine which inspections
apply.
Installation of ancillary equipment (e.g., power supplies,
terminal blocks, etc.) may be the responsibility of the
installer. Refer questions to your Motorola Program
Manager.
NOTE
Deficiencies
Notify responsible personnel of any deficiencies as soon as possible, if
the installer is not responsible for correcting the noted deficiencies.
Deficiencies may need to be corrected before any installation can start.
What to Inspect
The following external items should be inspected and compared against
any related site-specific documentation.
S Antennas
S External ground systems
S Clearances for units
S Mounting Structures
Additionally, for all sites the incoming power should be inspected and
compared against any related site-specific documentation.
Antenna and Transmission
Line Inspections
Documentation
The vendor(s) responsible for supplying other equipment have left
installation documentation at the site. Review this documentation and
compare it with any related site-specific documents.
Inspection
Inspect the following:
S Antenna and transmission line installation
S Grounding.
Structural Inspections and
Verifications
Site power
Verify with the site manager that site power has been previously checked
and meets the specifications stated in the site-specific documentation.
2