User's Manual Part 1

Installation Tools and Materials – continued
PRELIMINARY
1X SC480 BTS Hardware Installation, Optimization/ATP, and FRU
MAY 2004
1-12
Table 1-4: Recommended Tools and Materials for Rack Mounting
Hand Tools PurposeMaterials
Small Phillips Screwdriver Customer Supplied General purpose use
Hex Crimping Tool Various die sets
(Customer Supplied)
Create RF cabling and power/ground
cabling
RJ45 Crimping Tool (Tyco P/N 2–231652–1,
853400–0, 853400–1,
853400–7 or equivalent)
Customer Supplied
Create RJ11/RJ45 cabling
5/16 Breakaway Torque Wrench,
9–in. lb
Customer Supplied SMA Connectors
13/16 Breakaway Torque Wrench
38–in. lb
Customer Supplied N Connectors
Volt/Ohmmeter or Digital Multimeter Customer Supplied Voltage and continuity testing
Label Maker Customer Supplied General purpose marking
cCLPA Installation Handles Motorola P/N:
5587763T01
For installing the cCLPA
Wire Strippers Customer Supplied Accommodates 6 AWG to 26 AWG
RTV Sealant
(Customer Supplied)
Weatherproofing openings for cable
pass through
electrical tape
(Customer Supplied)
General purpose use
Fine Grit Sandpaper
(Customer Supplied)
Finishing coax cable surfaces
Cable Tie–wraps various
sizes.
(Customer Supplied)
General purpose dressing of cables
15–pin D–sub plug and
termination equipment
(Customer Supplied)
For RGPS cabling
BNC male style connectors
(Customer Supplied)
Coaxial span cable, interframe
cabling
N–male and N–female style
connectors for 1/2–in Heliax
(Customer Supplied)
Cabling between BTS, PA, and
Antenna
7/16 DIN connector for
1/2–in and 7/8–in Heliax
(Customer Supplied)
Antenna cabling
RF Cabling, 1/2–in and
7/8–in Heliax
Cabling between BTS, PA, and
Antenna
Braided Coax
(Customer Supplied)
Coaxial span cable, interframe
cabling
10AWG two–wire stranded
(Customer Supplied)
Power cabling
1