User's Manual Part 1

FCC Requriements – continued

MAY 2004 1X SC480 BTS Hardware Installation, Optimization/ATP, and FRU xxv

PRELIMINARY

Part 15.105(b) – Information to User

This equipment has been tested and found to comply with

thelimits for a Class B digital device, pursuant to Part 15

of theFCC Rules. These limits are designed to provide

reasonableprotection against harmful interference in a

residentialinstallation. This equipment generates, uses and

can radiate radiofrequency energy and, if not installed and

used in accordancewith the instructions, may cause harmful

interference to radiocommunications. However, there is no

guarantee thatinterference will not occur in a particular

installation. If thisequipment does cause harmful

interference to radio or televisionreception, which can be

determined by turning the equipmentOFF and ON, the user

is encouraged to try to correct theinterference by one or

more of the following measures:

S Reorient or relocate the receiving antenna.

S Increase the separation between the equipment and

receiver.

S Connect the equipment into an outlet on a circuit

different from that to which the receiver is connected.

S Consult the dealer or an experienced radio/TV

technician for help.

NOTE

Part 68 Requirements

This equipment complies with Part 68 of the Federal

CommunicationsCommission (FCC) Rules. A label on the GLI3 board,

easily visiblewith the board removed, contains the FCC Registration

Number for thisequipment. If requested, this information must be

provided to the telephone company.

FCC Part 68 Registered Devices

Device FCC Part 68 ID

SC480–800MHz 1X/EVDO See Note US: IHEDENANSC4801XDO

NOTE

The SC480–800MHz 1X/EVDO BTS is registered with an FCC part number

(US: IHEDENANSC4801XDO) which will cover all the internal cards and

modules.

The telephone company may make changes in its facilities, equipment,

operations, or procedures that could affect the operation of your T1. If

this happens, the telephone company will provide advance notice so that

you can modify your equipment as required to maintain uninterrupted

service.