User's Manual Part 1

Span Line, RGPS, and RF–GPS Cabling – continued
MAY 2004
4-71
1X SC480 BTS Hardware Installation, Optimization/ATP, and FRU
PRELIMINARY
Table 4-37: Procedure for Installing RF–GPS Antenna and Cabling
Step Action
5 Attach the grounding kit to the mounting pole.
6 Connect one (1) N connector of the 50–feet superflex cable to the N jack of the RF–GPS antenna cable
and route the other end of the cable down to the frame.
7 If not already done, attach RF–GPS Module to CBIO Board and secure using 4 M4 screws.
8 Route the cable to the RF–GPS connector at the rear of the BTS.
9 Connect cable to RF–GPS connector. See Figure 4-48.
4