User's Manual Part 1

Thermal Management Enclosure Installation – continued
PRELIMINARY
1X SC480 BTS Hardware Installation, Optimization/ATP, and FRU
MAY 2004
4-26
Table 4-15: Procedure to Install Mounting Bracket on a Wall
Step Action
1 Select a suitable wall position such that the bottom of the TME is a minimum of 1 meter above the
ground.
NOTE
Check site documentation for further information.
2 Position Wall Mounting Bracket on wall and mark hole locations.
3 Drill starter holes for the anchor bolts.
4 Secure Wall Mounting Bracket to wall using 8 M6 anchor bolts. Torque anchor bolts to 3.4 N–M (30
in–lbs).
n WARNING
The TME weighs 18 kg (40 lbs). One person is able to mount the TME on the Wall Mounting Bracket.
It is recommended that two people or one person using a mechanical lift mount the TME onto
mounting bracket.
Do not place the Compact BTS inside the TME prior to placing it on the mounting bracket.
Do not attach HMS to the TME prior to mounting the TME.
5 Hang TME on Wall Mounting Bracket. Mounting bar on the rear of the TME is set into the cutouts on
the Wall Mounting Bracket.
6 Secure the TME to the Wall Mounting Bracket using 6 M6 screws. Torque screws to 3.4 N–M (30
in–lbs). See Figure 4-18.
4