User's Manual Part 1

Connector Locations
MAY 2004
4-3
1X SC480 BTS Hardware Installation, Optimization/ATP, and FRU
PRELIMINARY
Connector Locations
Figure 4-1 shows the location of the cable connectors on the BTS. The
system configuration determines which connectors are used. Figure 4-2
is a detail of the connectors on the rear of the BTS.
Figure 4-1: Rear View of BTS
RGPS Connector and
SDCX Module are
shown.
Note:
1. The LAN Connections
should be terminated with
50–Ohm loads.
2. The Expansion TX and RX
ports should be terminated
with SMA 50–Ohm loads.
ti–cdma–wp–00311–v01–ildoc–ah
DAISY–CHAIN SYNC – OUT
SDCX KIT NO.
SDCX SERIAL NO.
DAISY–CHAIN POWER
SDCX POWER
EXPANSION FRAME SYNC – OUT
RF–GPD IN
PWR
4