User's Manual Part 1

Cable Description – continued
3-2 1X SC480 BTS Hardware Installation, Optimization/ATP, and FRU MAY 2004
PRELIMINARY
Customer I/O Connector
The recommended connector for Customer Input and Output is listed
below:
S Input Connector: Molex, terminla plugs, P/N 39352–0106
S Output Connector: Molex, terminla plugs, P/N 39352–0108
Cable Descriptions and Part
Numbers
Table 3-1 gives the cable descriptions and part numbers for the cables
used to install the BTS.
Table 3-1: Cable Descriptions and Part Numbers
Cable Qty. Part Number Description
A 2 Customer
Supplied
Ground cable, 6 -AWG, insulated copper wire. Requires one two–hole
lug connectors.
B 1–6 Andrew
LDF4–50
Customer
Supplied
Antenna Cable, 800 MHz, length selections: 10 m (31 ft.)
C 1
T472AA RGPS cable, 15 m (50 ft.)
T472AB RGPS cable, 38 m (125 ft.)
T472AC RGPS cable, 76 m (250 ft.)
T472AD RGPS cable, 152 m (500 ft.)
T472AE RGPS cable, 304 m (1000 ft.)
T472AF RGPS cable, 608 m (2000 ft.)
C1 1 3086433H07 Punchblock to CBIO Board, 15 pin D–connector on one end and loose
wires on the other end.
D 1 Customer
Supplied
Span cable, 4 or 8 conductors, 24–28 AWG stranded, twisted pair
E 1 Customer
Supplied
Customer Input/Output cable, 0–8 conductors, 18–24 AWG stranded
wire
F 2 Customer
Supplied
DC power cable with crimped lugs, 8–10 AWG, 10 m, stranded,
designed for –60 to –40 VDC power input
G 1 Customer
Supplied
RJ45 cable for BTS to cCLPA
H 1–11
3086039H18 RGPS Synchronization cable (part of kit SGKN4351A)
3086039H19 RGPS Synchronization cable (part of kit SGKN4352A)
J** 1 Supplied in Kit
SGRG4030
Local GPS Cable,
1
/
2
–inch coaxial, length = 50 ft. Two male N–type
connectors, one end to be terminated after routing of cable
table continued on next page
3