Instruction Manual
Table Of Contents
- Contents
- Figures
- Tables
- General Safety
- Introduction
- Preliminary Operations
- Optimization/Calibration
- Automated Acceptance Test Procedures (ATPs)
- Leaving the Site
- Basic Troubleshooting
- Data Sheets
- Test Matrix
- BBX Gain Set Point vs BTS Output
- CDMA Operating Frequency
- PN Offset/I & Q Register
- Test Equipment Preparation
- In-Service Calibration
- Index
Preparing the LMF
DRAFT
SC4812ET BTS Optimization/ATP — CDMA LMF
Apr 2001
3-10
Software and files for installation and updating of the LMF are provided
on CD ROM disks. The following installation items must be available:
LMF Program on CD ROM
LMF Binaries on CD ROM
CDF for each supported BTS (on diskette or available from the
CBSC)
CBSC File for each supported BTS (on diskette or available from the
CBSC)
The following section provides information and instructions for
installing and updating the LMF software and files.
LMF Operating System Installation
Follow the procedure in Table 3-3 to install the LMF operating system.
Table 3-3: LMF Operating System Installation
Step Action
1 Insert the LMF Program CD ROM into the LMF CD ROM drive.
– If the Setup screen is displayed, go to step 5.
– If the Setup screen is not displayed, proceed to step 2.
2 Click on the Start button.
3 Select Run.
4 In the Open box, enter d:\autorun and click on the OK button.
NOTE
If applicable, replace the letter d with the correct CD ROM drive letter.
. . . continued on next page
3