Instruction Manual
Table Of Contents
- Contents
- Figures
- Tables
- General Safety
- Introduction
- Preliminary Operations
- Optimization/Calibration
- Automated Acceptance Test Procedures (ATPs)
- Leaving the Site
- Basic Troubleshooting
- Data Sheets
- Test Matrix
- BBX Gain Set Point vs BTS Output
- CDMA Operating Frequency
- PN Offset/I & Q Register
- Test Equipment Preparation
- In-Service Calibration
- Index
Isolate Span Lines/Connect LMF – continued
DRAFT
SC4812ET BTS Optimization/ATP — CDMA LMF
Apr 2001
3-8
Table 3-1: Pin–Out for 50 Pin Punch Block
Site Component ColorPinSignal Name
RVC_TIP_A 30T
RVC_RING_A 30R
XMIT_TIP_A 31T
XMIT_RING_A 31R
RVC_TIP_B 32T
RVC_RING_B 32R
XMIT_TIP_B 33T
XMIT_RING_B 33R
RVC_TIP_C 34T
RVC_RING_C 34R
XMIT_TIP_C 35T
XMIT_RING_C 35R
SPAN
RVC_TIP_D 36T
RVC_RING_D 36R
XMIT_TIP_D 37T
XMIT_RING_D 37R
RVC_TIP_E 38T
RVC_RING_E 38R
XMIT_TIP_E 39T
XMIT_RING_E 39R
RVC_TIP_F 40T
RVC_RING_F 40R
XMIT_TIP_F 41T
XMIT_RING_F 41R
GPS_POWER_1+ 42T Blue
GPS_POWER_1– 42R Bk/Blue
GPS_POWER_2+ 43T Yellow
GPS_POWER_2– 43R Bk/Yellow
GPS_RX+ 44T White
GPS_RX– 44R White
RGPS
GPS_TX+ 45T Green
GPS_TX– 45R Green
Signal Ground (TDR+) 46T Red
Master Frame (TDR–) 46R Bk/Red
GPS_lpps+ 47T Brown
GPS_lpps– 47R Bk/Brn
Telco_Modem_T 48T
Phone Line
Telco_Modem_R 48R
Chasis Ground 49T
Reserved 49R
Miscellaneous
Reserved 50T
Reserved 50R
3