Instruction Manual
Table Of Contents
- Contents
- Figures
- Tables
- General Safety
- Introduction
- Preliminary Operations
- Optimization/Calibration
- Automated Acceptance Test Procedures (ATPs)
- Leaving the Site
- Basic Troubleshooting
- Data Sheets
- Test Matrix
- BBX Gain Set Point vs BTS Output
- CDMA Operating Frequency
- PN Offset/I & Q Register
- Test Equipment Preparation
- In-Service Calibration
- Index
Appendix B: FRU Optimization/ATP Test Matrix – continued
DRAFT
SC4812ET BTS Optimization/ATP — CDMA LMF
Apr 2001
B-4
Table B-3: SC 4812ET BTS Optimization and ATP Test Matrix
Doc
Tbl
#
Description
Directional Coupler (RX)
Directional Coupler (TX)
RX Filter
RX Cables
TX Cables
Multicoupler/Preselector
CIO
C–CCP Backplane
BBX2
MCC24/MCC8E
CSM
LFR/HSO
GPS
GLI2
LPA
LPA Filter Bandpass
Power Converters (See Note)
SWITCH CARD
LPA Combiner Filter 2:1
LPA Combiner Filter 4:1
LPA Backplane
Table 2-1
Initial Boards/Modules
Install, Preliminary
Operations, CDF Site
Equipage; etc.
Table 2-5
Initial Power-up
Table 3-6/
Table 3-8
Start LMF
Table 3-13/
Table 3-14
Download Code
Table 3-16
Enable CSMs
Table 3-19
GPS Initialization /
Verification
Table 3-20
LFR Initialization /
Verification
Table 3-33
TX Path Calibration
Table 3-34
Download Offsets to BBX2
Table 3-35
TX Path Calibration Audit
Table 4–1
Spectral Purity TX Mask
Table 4–1
Waveform Quality (rho)
Table 4–1
Pilot Time Offset
Table 4–1
Code Domain Power /
Noise Floor
Table 4–1
FER Test
NOTE
Replace power converters one card at a time so that power to the C–CCP shelf is not lost. If power to the shelf
is lost, all cards in the shelf must be downloaded again.
B