Instruction Manual
Table Of Contents
- Contents
- Figures
- Tables
- General Safety
- Introduction
- Preliminary Operations
- Optimization/Calibration
- Automated Acceptance Test Procedures (ATPs)
- Leaving the Site
- Basic Troubleshooting
- Data Sheets
- Test Matrix
- BBX Gain Set Point vs BTS Output
- CDMA Operating Frequency
- PN Offset/I & Q Register
- Test Equipment Preparation
- In-Service Calibration
- Index
Appendix A: Optimization (Pre–ATP) Data Sheets – continued
Apr 2001
A-5
SC4812ET BTS Optimization/ATP — CDMA LMF
DRAFT
GPS Receiver Operation
Table A-4: GPS Receiver Operation
OK Parameter Specification Comments
GPS Receiver Control Task State:
tracking satellites
Verify parameter
Initial Position Accuracy: Verify Estimated
or Surveyed
Current Position:
lat
lon
height
RECORD in
msec and cm also
convert to deg
min sec
Current Position: satellites tracked
Estimated:
(>4) satellites tracked,(>4) satellites visible
Surveyed:
(>
1) satellite tracked,(>4) satellites visible
Verify parameter
as appropriate:
GPS Receiver Status:Current Dilution of
Precision
(PDOP or HDOP): (<30)
Verify parameter
Current reference source:
Number: 0; Status: Good; Valid: Yes
Verify parameter
Comments:_________________________________________________________
A