Instruction Manual

Automated Acceptance Test Procedure – Overview – continued
Apr 2001
4-3
SC4812ET BTS Optimization/ATP — CDMA LMF
DRAFT
ATP Test Procedure
There are three different ATP testing options that can be performed to
completely test a BTS. Depending on your requirements, one of the
following ATP testing options should be run.
Table 4-1 provides the procedure to execute an ATP test. To completely
test a BTS, run the ATP tests according to one of the following ATP
testing options.
ATP Testing Option 1
 All TX/RX test
ATP Testing Option 2
 All TX test
 All RX test
ATP Testing Option 3
 TX Mask test
 Rho test
 Pilot Time Offset test
 Code Domain Power test
 FER test
The Full Optimization test can be run if you want the TX
path calibrated before all the TX and RX tests are run.
NOTE
If manual testing has been performed with the HP analyzer,
remove the manual control/system memory card from the
card slot and set the IO CONFIG to the Talk & Listen
mode before starting the automated testing.
IMPORTANT
*
Individual Acceptance Tests
The following individual ATP tests can be used to verify the results of
specific tests:
Spectral Purity TX Mask
This test verifies that the transmitted CDMA carrier waveform,
generated on each sector, meets the transmit spectral mask specification
with respect to the assigned CDF file values.
4