User's Manual

Prepare to Leave the Site

68P64115A18–1

Mar 2003

1X SC 4812T Lite BTS Optimization/ATP Software Release R2.16.1.x

DRAFT

5-4

Prepare to Leave the Site

Removing External Test Equipment

Perform the procedure in Table 5-3 to disconnect the test equipment and

configure the BTS for active service.

Table 5-3: Remove External Test Equipment

Step Action

n WARNING

Be sure no BBXs are keyed before performing this step. Failure to do so can result in personal injury

and damage to BTS LPAs.

Disconnect all external test equipment from all TX and RX connectors at the rear of the frame.

Reconnect and visually inspect all TX and RX antenna feed lines at the frame RF interface panel.

NOTE

Verify that all sector antenna feed lines are connected to the correct antenna connectors on the frame.

Crossed antenna cables will degrade call processing.

Reset All Devices and Initialize Site Remotely

Generally, devices in the BTS should not be left with data and code

loaded from the LMF. The configuration data and code loads used for

normal operation could be different from those stored in the LMF files.

By resetting all devices, the required data and code can be loaded from

the CBSC using the DLM when spans are again active.

To reset all devices and have the OMCR/CBSC bring up the site

remotely, perform the procedure in Table 5-4.

Table 5-4: Reset BTS Devices and Remote Site Initialization

Step Action

1 Terminate the LMF session by following the procedures in Table 5-6.

2 Cycle BTS power off, as specified in Table 2-9 and Table 2-10, and on, as specified in Table 2-11 and

Table 2-12.

3 Reconnect spans by following the procedure in Table 5-7.

4 Notify the OMCR/CBSC to take control of the site and download code and data to the BTS.

5 Verify the CBSC can communicate with the GLIs.