User's Manual

Table Of Contents

BTS Power Cabling

68P64115A19–4

Mar 2003

1X SC 4812T-MC BTS Hardware Installation - Software Release R2.16.1.x

CONTROLLED INTRODUCTION

2-47

Figure 2-23: DC Power Connector/Filter

ÂÂÂÂÂÂÂÂÂÂÂÂ

ti-CDMA-WP-00194-v01-ildoc-ftw

Input

Connector/

DC Filter

2nd DC FILTER

OPTIONAL

(–)

(+)

Connector

Housing

CONTACT

(+) DC CABLE

DC CABLE (–)

CONTACT

Tools and Equipment Required

The following tools are required to install the power cable on the BTS:

Cable M – The cable diameter and lug style depend on the length of

cable required. Appropriate codes and standards must be followed to

determine the correct wire size and type (see Table 2-35). A variety of

lug sizes are available from Motorola for the various cable sizes and

types that may be selected (see Table 2-36).

Table 2-36: Lug Part Numbers

Lug Part Numbers Cable Type

CGDS6320G1 AWG 2/0

CGDS6320G5 AWG 3/0

CGDS6320G2 AWG 4/0

NOTE

The cable diameter and lug style depend on the length of cable

required. Appropriate codes and standards MUST be followed to

determine the correct wire size and type. A variety of lug sizes

are available from Motorola for the various cable sizes and types

that may be selected. Lug size is dependent on the gauge and

type of cable selected for the frame power feed.