User's Manual

Setting Frame C-CCP Shelf Configuration Switch
68P64115A19–4
Mar 2003
1X SC 4812T-MC BTS Hardware Installation - Software Release R2.16.1.x
CONTROLLED INTRODUCTION
3-16
Setting Frame C-CCP Shelf Configuration Switch
When the frame is a Starter BTS, the backplane switch settings behind
the fan module nearest the breaker panel must be set to the ON position
(see Figure 3-10).
NOTE
The switch setting must be verified and set before power is
applied to the BTS equipment!
NOTE
Dip switch settings are only changed in the Expansion frame if
the system is running software release 2.9 or later, AND the site
is configured as a logical BTS.
Figure 3-10: Backplane DIP Switch Settings
19 mm Filter Panel
Power Supply
AMR / MACH
HSO CSM CSM
39 mm Filter Panel
AMR / MACH
GLI–1GLI–2
MCC–6
BBX–1 BBX–2 BBX–3 BBX–4 BBX–5 BBX–6
BBX–R
Switch
MPCMPC
MCIO
BBX–7
BBX–8 BBX–9
BBX–10
BBX–11
BBX–12
MCC–5 MCC–4 MCC–3 MCC–2 MCC–1
MCC–12
MCC–11
MCC–10
MCC–9 MCC–8 MCC–7
Power Supply Power Supply
CCD CCD
ON
OFF
SC 4812T–MC C–CCP SHELF
FAN MODULE
REMOVED
STARTER
FRAME
SETTING
ON
OFF
EXPANSION
FRAME
SETTING
BOTTOM / TOP
RIGHT / LEFT
MODEM_FRAME_ID_1 MODEM_FRAME_ID_0
BOTTOM / TOP
RIGHT / LEFT
MODEM_FRAME_ID_1 MODEM_FRAME_ID_0
ti-CDMA-WP-00211-v01-ildoc-ftw
SPEED
CONTROLLED
FA N
MODULE
REAR
FRONT
PWR/ALM
SPEED
CONTROLLED
FA N
MODULE
REAR
FRONT
PWR/ALM
3