User's Manual

Troubleshooting: Span Control Link68P64115A18–1

Mar 2003

1X SC 4812T Lite BTS Optimization/ATP Software Release R2.16.1.x

DRAFT

6-39

Table 6-32: Set BTS Span Parameter Configuration

n ActionStep

10 At the entry prompt (>), enter the designator from the list for the span to be changed as shown in

the following example:

> a <cr>

The terminal will display a response similar to the following:

COMMAND SYNTAX: config ni equal a equal

Next available options:

LIST – equal : Span Equalization

0 : 0–131 feet (default for T1/J1)

1 : 132–262 feet

2 : 263–393 feet

3 : 394–524 feet

4 : 525–655 feet

5 : LONG HAUL

6 : 75 OHM

7 : 120 OHM (default for E1)

11 At the entry prompt (>), enter the code for the required equalization from the list as shown in the

following example:

> 0 <cr>

The terminal will display a response similar to the following:

> 0

The value has been programmed. It will take effect after the next reset.

GLI2>

12 Repeat steps 9 through 11 for each in–use span.

* IMPORTANT

After executing the config ni format, config ni linkspeed, and/or config ni equal

commands, the affected MGLI/GLI board MUST be reset and reloaded for changes to take effect.

Although defaults are shown, always consult site specific documentation for span type and

linkspeed used at the site.

Press the RESET button on the MGLI2/GLI2 for changes to take effect.

. . . continued on next page