User's Manual

Troubleshooting: Span Control Link68P64115A18–1

Mar 2003

1X SC 4812T Lite BTS Optimization/ATP Software Release R2.16.1.x

DRAFT

6-37

Set BTS Site Span Configuration

NOTE

Perform the following procedure ONLY if span configurations

loaded in the MGLI2/GLI2s do not match those in the

OMCR/CBSC data base, AND ONLY when the exact

configuration data is available. Loading incorrect span

configuration data will render the site inoperable.

Table 6-32: Set BTS Span Parameter Configuration

n Step Action

1 If not previously done, connect the LMF computer to the MMI port on the applicable

MGLI2/GLI2 as shown in Figure 6-5.

2 If there is no MMI communication session in progress with the applicable MGLI2/GLI2, initiate

one by using the Windows desktop shortcut icon (refer to Table 3-10).

3 At the GLI2> prompt, enter:

config ni format <option> <cr>

The terminal will display a response similar to the following:

COMMAND SYNTAX: config ni format option

Next available options:

LIST – option : Span Option

E1_1 : E1_1 – E1 HDB3 CRC4 no TS16

E1_2 : E1_2 – E1 HDB3 no CRC4 no TS16

E1_3 : E1_3 – E1 HDB3 CRC4 TS16

E1_4 : E1_4 – E1 HDB3 no CRC4 TS16

T1_1 : T1_1 – D4, AMI, No ZCS

T1_2 : T1_2 – ESF, B8ZS

J1_1 : J1_1 – ESF, B8ZS (Japan) – Default

J1_2 : J1_2 – ESF, B8ZS

T1_3 : T1_3 – D4, AMI, ZCS>

NOTE

With this command, all active (in–use) spans will be set to the same format.

To set or change the span type, enter the correct option from the list at the entry prompt (>), as

shown in the following example:

> T1_2 <cr>

NOTE

The entry is case–sensitive and must be typed exactly as it appears in the list. If the entry is typed

incorrectly, a response similar to the following will be displayed:

CP: Invalid command

GLI2>

5 An acknowledgement similar to the following will be displayed:

The value has been programmed. It will take effect after the next reset.

GLI2>

. . . continued on next page