User's Manual

Index
68P64115A18–1
DRAFT
Mar 2003
1X SC 4812T Lite BTS Optimization/ATP Software Release R2.16.1.x
Index-3
Broad Band Receiver. See BBX
BTS
download, 3-36
Ethernet LAN interconnect diagram, 3-33
LMF connection, 3-16, 3-17
log out of session, 5-5
RX sensitivity/frame error rate, 4-16
system software download, 3-4
BTS Frame Erasure Rate. See FER
BTS Log In Procedure, GUI, 3-26
BTS login
CLI environment, 3-28
General, 3-26
GUI environment, 3-26
BTS Logout
CLI environment, 3-30
GUI environment, 3-29
Create CAL File, 3-97
C
cable calibration, automatic, test set–up, 3-60, 3-61
Advantest R3267/R3562, 3-61
Advantest R3465, 3-60
Agilent 8935, 3-60
Agilent E4406A/E4432B, 3-61, 3-62, 3-71
CyberTest, 3-60
HP 8921A, 3-60
CAL file. See calibration data file
Calibrate Test Cabling Using Signal Generator &
Spectrum Analyzer, 3-79
Calibrating, Test Equipment, 3-76
Calibrating Cables, Overview, 3-77
Calibrating Test Cable Setup, PCS Interface
HP83236B, F-29
Calibrating Test Cabling using Communications
System Analyzer, 3-78
Calibration, In–Service, H-21
calibration
calibration data file, 3-84
Gigatronics 8542B, F-28
Calibration Audit failure, 6-11
calibration data file, description of, 3-84
Cannot communicate to Communications Analyzer,
6-7
Cannot communicate to Power Meter, 6-6
Cannot Download DATA to any device card, 6-8
Cannot ENABLE device, 6-9
Cannot Log into cell–site, 6-3
Cannot perform Code Domain Noise Power
measurement, 6-16
Cannot perform Rho or pilot time offset
measurement, 6-15
Cannot perform Txmask measurement, 6-15
CDF, 3-3
site equipage verification, 3-4
site type and equipage data information, 2-2
CDMA
allocation diagram for the North American, cellular
telephone frequency spectrum, E-5
optimization/ATP test matrix, C-2
subscriber mobile radiotelephone, optional test
equipment, 1-12
Cell Site
equipage verification, 2-2
types configuration, 3-3
Cell Site Data File. See CDF
CIO Connectors, 6-21
CLI, 3-25
Clock Sync Module. See CSM
Code domain power/noise floor
acceptance test, 4-25
analyzer display, 4-26
Command Line Interface, 3-25
Communication test set, rear panel, F-15, F-17
Communications test set. See Test equipment
communications test set, TX acceptance tests, 4-7
Connect BTS E1/T1 spans, 5-6
Connect BTS T1/E1 spans, 5-6
Connecting test equipment to the BTS, 3-55
Connector Functionality
Backplane, Troubleshooting, 6-20
Troubleshooting, Backplane, 6-20
Control, TX output verification, 4-7
Copy CBSC CDF Files to the LMF, 3-11
Copying CAL files from CDMA LMF to the CBSC,
5-2
Copying CAL files to the CBSC, 5-2
CSM
clock source, select, 3-41
enable, 3-42
LEDs, 3-45
system description, 3-44
CSM clock source, select, 3-41