User Manual

RF Cabinet Interconnect Cables

Jan 2002

H-1

SC4812ET BTS Optimization/ATP — CDMA LMF

SC 4812ET Intra–Cabinet

Cabling

This appendix provides the identification and location of the cables

connecting the components which make up the SC 4812ET RF cabinet.

The number of cables and components incorporated in the RF cabinet

will vary depending on the the manner in which the cabinet is equipped.

For example, a 3 sector, 2 carrier system will require less components

and less cables than a 6 sector 2 carrier system.

Refer to Table H-1 and Figure H-1 through Figure H-19 for the cable

you wish to research.

In some cases cables with the same number are used to

connect two different signalling paths. These cables are

designated A & B and the point they connect to and from

is also designated A & B. Ensure the correct cable (A or B)

is connected to the correct designation (A or B) connector

or plug.

IMPORTANT

Table H-1 : 4812ET RF CABINET INTER–CONNECT CABLES

DRDC, Combiner, Trunking Backplane Cables

CABLE # FROM NOTE’s TO

3064795A05 TX CIO Figure H-6 Trunking BP

3064735A10 TX Trunking BP Figure H-5 Combiner Connector Pnl

3064735A07 TX Combiner

See Figure H-1, Figure H-11,

Figure H-12, Figure H-13, and

Figure H-14

DRDC

3064735A11 TX Combiner (See Above) DRDC

3064735A12 TX Combiner (See Above) DRDC

3064795A07 TX CIO Figure H-11 Trunking BP

3086435H01 TX Combiner QDS PkZ Adptr

3086435H02 TX Combiner QDS PkZ Adptr

3086435H03 TX Combiner QDS PkZ Adptr

3086168H01 Power LPA PDA Figure H-5 Trunk BP

C–CCP Cables

CABLE # FROM NOTE’s TO

3064809A01 Power CCCP/PDA See Figure H-1 & Figure H-5 C–CCP Backplane

3064899A04 LAN I/O A in See Figure H-1 & Figure H-5 C–CCP LAN I/O A In

. . . continued on next page