User Manual
Test Equipment Preparation – continued
Jan 2002
F-5
SC4812ET BTS Optimization/ATP — CDMA LMF
HP8921A System Connectivity
Test
Follow the steps in Table F-3 to verify that the connections between the
PCS Interface and the HP8921A are correct and cables are intact. The
software also performs basic functionality checks of each instrument.
Disconnect other GPIB devices, especially system
controllers, from the system before running the
connectivity software.
IMPORTANT
*
Table F-3: System Connectivity
Step Action
* IMPORTANT
– Perform this procedure after test equipment has been allowed to warm–up and stabilize for a
minimum of 60 minutes.
1 Insert HP 83236A Manual Control/System card into memory card slot.
2 Press the [PRESET] pushbutton.
3 Press the Screen Control [TESTS] pushbutton to display the “Tests” Main Menu screen.
4 Position the cursor at Select Procedure Location and select it by pressing the cursor control knob. In
the Choices selection box, select Card.
5 Position the cursor at Select Procedure Filename and select it by pressing the cursor control knob. In
the Choices selection box, select SYS_CONN.
6 Position the cursor at RUN TEST and select it. The software will prompt you through the
connectivity setup.
7 Do the following when the test is complete,
position cursor on STOP TEST and select it
OR press the [K5] pushbutton.
8 To return to the main menu, press the [K5] pushbutton.
9 Press the [PRESET] pushbutton.
F