User Manual

Index continued
Jan 2002
SC4812ET BTS Optimization/ATP CDMA LMF
Index-7
Test equipment connections , F-1
preliminary Agilent E4406A/E4432B setup, F-10
Test Equipment Policy, 1-4
Test Equipment Setup, 3-45
Test Equipment Setup Calibration for TX Bay Level
Offset, 3-70, F-15
Test Equipment Setup Chart, 3-47
Test equipment setup RF path calibration, 3-77
Test Set Calibration, 3-63
Timing Reference Cables, 1-9
Transmit TX path audit, 3-82
Transmit TX path calibration, 3-78
Transmit/Receive Module TRX, 1-28
Troubleshooting
DC Power Problems, 6-17
Span Problems no control link, 6-29
TX and RX Signal Routing, 6-19
Troubleshooting CSM Checklist, 6-11
Troubleshooting Forward Link Failure (BTS Passed
Reduced ATP), 6-8
TSU NAM, programming
description, 3-92
parameter ranges, 3-93
parameters, 3-92
procedure, 3-98
TX
antenna VSWR, test data sheets, A-15, A-16
BLO test data sheets, A-8, A-13
TX & RX Path Calibration, 3-73
TX and RX Frequency vs Channel , D-2
TX and RX Signal Routing, CCCP Backplane
Troubleshooting, 6-19
TX Audit Test, 3-83
TX Bay Level Offset and TX ATP test equipment
setup calibration, 3-69
TX calibration, setup, 3-52
Advantest R3267, 3-54
Advantest R3465, 3-53
Agilent 8935, 3-52
Agilent E4406A, 3-54
CyberTest, 3-52
HP 8921A, 3-53
TX Code Domain Power ATP, 4-11
tx fine adjust, E-1
TX Mask Verification, spectrum analyzer display,
illustration, 4-8
TX Output Acceptance Tests Introduction
Code domain power, 4-5
Pilot time offset, 4-5
Spectral purity TX mask, 4-5
Waveform Quality (rho), 4-5
TX Path Calibration, 3-74
TX Pilot Time Offset ATP, 4-10
TX Spectral Purity Transmit Mask ATP, 4-7
TX Waveform Quality (rho) ATP, 4-9
TX/RX OUT Connections, 4-3
txmask test, 4-7
U
Updating CDMA LMF Files, 5-1
V
Verify, test equipment used, test data sheets, A-1
Verify GLI ROM code load, 3-29
Verify Span Parameter Configuration, procedure, 5-3
Virtual BTS, 1-14
W
Walsh channels, 4-11
X
XCVR Backplane Troubleshooting, 6-13
Xircom Model PE310B2, LMF to BTS connection,
3-17